Electric Power ›› 2026, Vol. 59 ›› Issue (1): 84-96.DOI: 10.11930/j.issn.1004-9649.202508038

• Energy and Electricity Data Elements and Artificial Intelligence Applications • Previous Articles     Next Articles

Fault current calculation method for multi-terminal DC distribution networks considering multiple distributed generation

JIA Dongli1(), REN Zhaoying1, LIU Keyan1, YE Xueshun1, LI Yuetao2, XU Limei2()   

  1. 1. China Electric Power Research Institute Co., Ltd., Beijing 100192, China
    2. Department of Electrical Engineering, Southwest Minzu University, Chengdu 610225, China
  • Received:2025-08-20 Revised:2025-12-05 Online:2026-01-13 Published:2026-01-28
  • Supported by:
    This work is supported by Sichuan Provincial Natural Science Foundation (No.2022NSFSC1913); Science and Technology Project of SGCC (No.5108-202218280A-2-370-XG).

Abstract:

In DC distribution networks, short-circuit faults can cause the current to rise to several times the normal operating level in an extremely short period, posing severe challenges to system protection and safe operation. The presence of multiple distributed generators (DGs) in DC distribution networks and the diversity of their grid-connected converters as well as the complex coupling relationships make it difficult to analyze fault characteristics and accurately calculate fault currents, which is unfavorable to the design of protection strategies. To address this issue, this paper proposes a fault current calculation model for DC distribution networks with multiple DGs. First, a fault equivalent circuit of the voltage source converter (VSC) is established, and the fault response characteristics of PV Boost converters, distributed wind power machine-side converters (MSC), energy storage dual active bridge (DAB) converters and VSCs are analyzed to construct multi-scenario fault equivalent circuits. Second, proceeding from the multi-stage transient response process of fault current, a fault current calculation model is built, covering the initial steady-state stage before fault, DC bus discharge stage, diode freewheeling stage and steady-state stage after fault. Then, based on the established multi-stage fault current calculation model, the key factors affecting the peak fault current are analyzed. Finally, taking a multi-terminal DC distribution network with multiple DGs as an example, the theoretical calculation results are compared with the Matlab/Simulink simulation results to verify the accuracy of the proposed model.

Key words: multi-terminal DC distribution network, distributed generation, fault equivalent circuit, fault current calculation, peak current