中国电力 ›› 2018, Vol. 51 ›› Issue (10): 123-129.DOI: 10.11930/j.issn.1004-9649.201805182

• 节能与环保 • 上一篇    下一篇

湿式电除尘器性能测试方法及排放特征研究

李皓然1, 刘含笑2, 赵琳2, 颜士娟2, 冯国华2, 方小伟2   

  1. 1. 国网冀北电力有限公司技能培训中心, 河北 保定 071000;
    2. 浙江菲达环保科技股份有限公司, 浙江 诸暨 311800
  • 收稿日期:2018-05-26 修回日期:2018-06-19 出版日期:2018-10-05 发布日期:2018-10-12
  • 通讯作者: 刘含笑(1987-),男,通信作者,工程师,硕士,从事PM2.5捕集增效技术研究,E-mail:gutounan@163.com
  • 作者简介:李皓然(1989-),男,工程师,从事电力电子与电力传动方面的研究,E-mail:jsj07tong2@126.com
  • 基金资助:
    国家重点研发计划资助项目(2017YFC0804704;2016YFC0209107)。

Study on Performance Testing Method and Emission Characteristics of Wet Electrostatic Precipitators

LI Haoran1, LIU Hanxiao2, ZHAO Lin2, YAN Shijuan2, FENG Guohua2, FANG Xiaowei2   

  1. 1. State Grid Jibei Electric Power Company Limited Skills Training Center, Baoding 071000, China;
    2. Zhejiang Feida Environmental Science & Technology Co., Ltd., Zhuji 311800, China
  • Received:2018-05-26 Revised:2018-06-19 Online:2018-10-05 Published:2018-10-12
  • Supported by:
    This work is supported by National Key Research and Development Program of China (No.2017YFC0804704,No.2016YFC0209107).

摘要: 湿式电除尘器收尘极被水膜覆盖,放电区域存在水雾,无振打二次扬尘,且细颗粒物团聚现象显著,可有效减少细颗粒物、SO3等排放。采用一体化采样头(内置滤膜)采集颗粒物,采用重量法(PM-10)和电荷法(ELPI)测定PM2.5;采用冷凝法或冷凝法与异丙醇吸收相结合的采样方法测定SO3。测定结果表明,不同型式的湿式电除尘器颗粒物、PM2.5一般分别在2~5mg/m3及3mg/m3以下,除尘效率一般在75%~95%,金属极板湿式电除尘器为连续喷淋,因不存在细颗粒物的二次扬尘,颗粒物排放可达1mg/m3以下;不同型式的湿式电除尘器SO3排放一般在5mg/m3以下,SO3脱除效率一般在60%~80%,导电玻璃钢湿式电除尘器板电流密度一般比金属极板湿式电除尘器大,因此其SO3脱除效率普遍更高一些。

关键词: 超低排放, 燃煤电厂, 湿式电除尘器, 颗粒物, SO3, PM2.5

Abstract: Due to the water film covered dust collecting electrode, the existence of water mist in the discharge area and the absence of vibration and secondary dust extraction, particularly its mechanism to agglomerate the fine particles significantly, the wet electrostatic precipitator (WESP) is very effective to reduce the emission of fine particles such as SO3. Particulate matter is collected by integrated sampling head (built-in filter membrane), while PM2.5 is determined by gravimetric method (PM-10) and charge method (ELPI), and SO3 is determined by condensation method or condensation method combined with isopropanol absorption. The results show that the concentration of particulate matter in different types of WESP varies from 2mg/m3 to 5 mg/m3, and PM2.5 is lower than 3 mg/m3 with the dust removal efficiency around 75%~95%. Continuous spray is applied in the metal plate type wet electrostatic precipitator. Since there is no secondary dust of fine particles, the emission of particulate matter is kept below 1mg/m3. The emissions characterization of SO3 in different types of WESP is generally below 5mg/m3, with the SO3 removal efficiency about 60%~80%. The current density of conductive fiberglass WESP is generally greater than that of metal plate WESP, hence its SO3 removal efficiency is generally higher.

Key words: ultra-low emission, coal-fired power plant, WESP, particles, SO3, PM2.5

中图分类号: