双分裂导线连接金具异常发热原因分析与研究

doi:10.11930/j.issn.1004-9649.2016.05.035.04

摘要/Abstract

摘要： 针对一起双分裂导线连接金具异常发热的缺陷进行了深入分析，发现耐张引流线夹接触不良是导致连接金具发热的主要原因。通过进一步的建模与仿真计算发现，随着双分裂导线某子导线耐张引流线夹接触电阻的逐步增大，该线夹处的发热功率呈现逐步增大的趋势，当接触电阻增大到一定程度后，由于子导线的分流作用，该线夹处的发热现象会逐步转移至连接金具，而接触电阻的拐点电阻的大小与连接金具本身的电阻值密切相关。通过这一特征规律的研究，为红外有效检测输电线路连接金具和耐张引流线夹的发热缺陷提供了参考依据。

关键词: 输电线路, 双分裂导线, 连接金具, 异常发热, 红外检测

Abstract: The abnormal heating of strain clamp is one of the most common defects of the overhead transmission lines. The abnormal heating of the link fittings is, however, very rare because the link fittings generally carry mechanical load instead of current. In this paper, an in-depth analysis is made on one abnormal heating defect of the link fittings for double-bundled conductor, and the result indicates that the main causes for the abnormal heating of the link fittings are the poor contact of the strain clamp. Further modeling and simulation analysis shows that the heating power of the strain clamp of a sub-conductor rises with the increase of the corresponding contact resistance. When the contact resistance increases to a certain extent, the heating of the clamp will gradually transfer to the link fittings because of the shunting effect of the sub-conductor, and the value of the contact resistance at the turning point is closely related to the resistance value of the link fittings. This research can provide a valuable reference for infrared detection of the abnormal heating of the strain clamps or link fittings for overhead transmission lines.

Key words: transmission line, double-bundled conductor, link fittings, abnormal heating, infrared detection

中图分类号:

TM75

李阳林，周龙武，张宇，邹建章,饶斌斌，况燕军. 双分裂导线连接金具异常发热原因分析与研究[J]. 中国电力, 2016, 49(5): 35-38.

LI Yanglin, ZHOU Longwu, ZHANG Yu, ZOU Jianzhang, RAO Binbin, KUANG Yanjun. Analysis on the Abnormal Heating of the Link Fittings for Double-Bundled Conductors[J]. Electric Power, 2016, 49(5): 35-38.

导出引用管理器 EndNote|Ris|BibTeX

链接本文: https://www.electricpower.com.cn/CN/10.11930/j.issn.1004-9649.2016.05.035.04

https://www.electricpower.com.cn/CN/Y2016/V49/I5/35

参考文献

[1] 董吉谔. 电力金具手册[M]. 3版. 北京：中国电力出版社，2010．
[2] 夏德森．耐张线夹在架空线路中的应用[J]．电力金具，2008，21（１）：7-14．
XIA Desen． Application of strain clamp in the overhead lines [J]．Electric Power Fittings, 2008, 21(1): 7-14．
[3] 雷冬云，石凯，牛捷，等. ±800 kV特高压直流输电线路引流板发热带电处置方法[J]. 中国电力，２０１５，４８（７）：３１－３３．
LEI Dongyun, SHI Kai, NIU Jie, et al. Solution for heat-failure of drainage plate of ±800 kV UHV DC transmission line[J]. Electric Power, 2015, 48(7): 31-33.
[4] 肖小辉，杜娥，谌青昊，等. 高压输电线路红外图像的边缘检测[J]. 中国电力，２００５，３８（１）：３１－３３.
XIAO Xiaohui, DU E, CHEN Qinghao, et al. Infrared image edge detection of high-voltage transmission line[J]. Electric Power, 2005, 38(1): 31-33
[5] 郭贤潇，李炜，蔡汉生. 高压输电线路红外检测初探[J]. 高电压技术，１９９６，２５（２）：３２－３４．
GUO Xiansha, LI Wei, CAI Haisheng. Primary investigation on infrared diagnosis of HV transmission lines[J]. High Voltage Engineering, 1996, 25(2): 32-34.
[6] 厉天威，黄文京，何民，等. 有限元法在高压输电线路线夹能量损耗计算中的应用[J]. 电网技术，２０１１，３５（４）：２１８－２２２．
LI Tianwei, HUANG Wenjing, HE Min, et al. Power loss calculation of clamps for high voltage transmission line by finite element method [J]. Power System Technology, 2011, 35(4): 218-222.
[7] 林杰，刘刚，张海鹏，等．架空线路并沟线夹温度分布研究[J]．电力系统保护与控制，2013，4１（２４）：88-94．
LIN Jie, LIU Gang, ZHANG Haipeng, et al． Research of temperature distribution of overhead lines parallel groove clamp[J]． Power System Protection and Control, 2013, 41(24): 88-94．
[8] 赵墨林，张景生，阎军，等. 温差比理论的确立及其在红外检测中的应用[J]. 中国电力，１９９８，３１（５）：４７－４９
ZHAO Molin, ZHANG Jinsheng, YAN Jun, et al． Establishment and studying of the theory of temperature difference ratio in infrared measurement [J]. Electric Power, 1998, 31(5): 47-49.
[9] 郭晓飞，李拥春，赵元林．耐张引流发热的分析与处理[J]．电气技术，２０１０，２３（８）：１３６－１３９．
GUO Xiaofei, LI Yongchun, ZHAO Yuanlin． The analysis and process about high temperature of elementary streams [J]．Electrical Technology, 2010, 23(8): 136-139．
[10] 彭晋英． JBL系统绝缘并沟线夹烧损分析及改进措施[J]．电力学报，２００９，２４（２）：１５９－１６０．
PENG Jinying. The burning loss analysis of the insulating parallel groove clamps of JBL series & measures for improvement[J]. Journal of Electric Power, 2009, 24(2): 159-160.
[11] 胡加瑞，谢亿，刘纯，等．输电线路耐张线夹典型缺陷探析[J]．华北电力技术，２０１３，３４（４）：３４－３７．
HU Jiarui, XIE Yi, LIU Chun, et al． Analysis on typical defect of strain clamp [J]． North China Electric Power, 2013, 34(4): 34-37．
[12] 崔明，贾晨，王朔，等．导线与线夹接触不良发热的热像特征[J]．吉林电力，２０１３，４１（６）：３６－３８．
CUI Ming, JIA Chen, WANG Shuo, et al． Thermal image characteristic based on poor contact between conductor and clap[J]． Jilin Electric Power, 2013, 41(6): 36-38．
[13] 李荣超．耐张跳线过渡装置相关金具烧伤的分析及治理[J]．湖北电力，２００１，２５（３）：３３－３５．
LI Rongchao． Analysis and treatment for heat corrosion of fittings in the tension jumper line transition device[J]． Hubei Electric Power, 2001, 25(3): 33-35．
[14] 彭向阳，刘毅刚，张穗强． OPGW光纤复合架空地线异常发热现场测量分析及仿真[J]．电网技术，２０１２，３６（２）：２０６－２１１．
PENG Xiangyang, LIU Yigang, ZHANG Suiqiang． On-site measurement based analysis and simulation of abnormal heating of optical fiber composite overhead ground wires [J]． Power System Technology, 2012, 36(2): 206-211．
[15] 李杰，陈希，林卫铭，等．光纤复合架空地线（ＯＰＧＷ）热性能的研究[J]．电网技术，２００６，３０（１）：８９－９３．
LI Jie, CHEN Xi, LIN Weiming, et al． Study on heat properties of optical fiber composite overhead ground wires [J]． Power System Technology, 2006, 30(1): 89-93．
[16] 黄巍，程泳，董建新，等． 500 kV架空地线金具发热的分析与对策[J]．浙江电力，201３，３６（１１）：３６－３９．
HUANG Wei, CHENG Yong， DONG Jianxin, et al． Analysis and countermeasure of hardware heating for 500 kV overhead ground wire [J]． Zhejiang Electric Power, 2013, 36(11): 36-39．
[17] 周欣佳．架空地线连接金具发热的原因分析及处理办法[J]．上海电力，２０１１，２５（３）：２７８－２８１．
ZHOU Xinjia． The analysis and process of hardware heating for overhead ground wires[J]． Shanghai Electric Power, 2011, 25(3):278-281．
[18] 张殿生．电力工程高压送电线路设计手册[M]．北京：中国电力出版社，2003：16-20．