基于信息融合技术的磨煤机负荷特征信息提取方法

doi:10.11930/j.issn.1004-9649.2014.12.45.3

摘要/Abstract

摘要： 磨煤机噪声信号含有能够表征磨煤机负荷的重要信息,是判断磨煤机运行状态的重要信号,但噪声信号各频段对负荷表征的灵敏度不同,仅靠噪声信号能量难以获取准确可靠的负荷变化信息。为此,研究出一种新的磨煤机负荷特征信息提取方法：利用信息融合技术中的多传感器一致性检测原理,将对负荷反应灵敏的多个磨煤机噪声特征频段提取出来,再按照最小二乘方法融合特征频段功率标定值,得到表征磨煤机负荷的特征信息。通过现场采集的磨煤机噪声信号,对所研究的方法进行了仿真验证,结果表明该方法有效可靠。

关键词: 火电厂, 磨煤机噪声, 磨煤机负荷, 一致性检测, 特征信息

Abstract: The noise signals of ball mills contain important information on mill loads and are critical for mill condition determination However. because of the load sensitivity variety of their frequency spectrum,it is difficult to acquire the accurate and reliable information of load change. In this paper, a novel load feature extraction method is proposed. This method adopts the multi sensor consistency check algorithm to extract the mill noise characteristic frequency bandsthat are sensitive to the load response and obtain the mill load characteristic information by following the least square principle to fuse the scale value of characteristic frequency bands. The noise signals are gathered on site and used to take the simulation test on the new approach. The test results prove that the new method is effective and reliable.

Key words: power plant, mill noise, mill load, consistency measuring, characteristic information

中图分类号:

TP274

王靖程, 任志文, 周昭亮, 舒进. 基于信息融合技术的磨煤机负荷特征信息提取方法[J]. 中国电力, 2014, 47(12): 45-48.

WANG Jing-cheng, REN Zhi-wen, ZHOU Zhao-liang, SHU Jin. Information Fusion Technology Based Feature Extraction Method for Ball Mill Load Measurement[J]. Electric Power, 2014, 47(12): 45-48.

导出引用管理器 EndNote|Ris|BibTeX

链接本文: https://www.electricpower.com.cn/CN/10.11930/j.issn.1004-9649.2014.12.45.3

https://www.electricpower.com.cn/CN/Y2014/V47/I12/45

参考文献

[1] MOYS MH. The measurement of parameters describing the dynamic behaviour of the load in a grinding mill[C]// International Conference On Mineral Science and Technology, 1984: 205-219.
[2] MOYS MH. Measurement of slurry properties and load behaviour in grinding mills[C]// Applied Measurements in Mineral and Metallurgical Processing IFAC, Transvaal, South Africa, 1988: 3-10.
[3] MULAR AL, BURKERT A. Automatic control of semiautogenous grinding(SAG) circuits[C]// International Conference On: Autogenous and Semiautogenous Grinding Technology, 1989: 651-668.
[4] 司刚全,张蕊,刘建民,等. 自寻优-模糊自适应采样PI控制在钢球磨煤机负荷控制中的应用[J]. 热力发电,2007,36（11）：52-55.
SI Gang-quan, ZHANG Rui, LIU Jian-min, et al . Application of self-optimizing and fuzzy self-adapting sampling PI control in mill load control system of thermal power plant[J]. Thermal Power Generation, 2007, 36(11): 52-55.
[5] 王靖程,孟维东,曹晖,等. 钢球磨煤机中贮式制粉优化控制系统的开发与应用[J]. 热力发电,2007,36（8）：79-83.
WANG Jing-cheng, MENG Wei-dong, CAO Hui, et al . Development and application of optimized control system for coal pulverizing system with intermediate storage bunker for ball mills[J]. Thermal Power Generation, 2007, 36(8): 79-83.
[6] 武桐,李鹏飞,司刚锋,等. 火电厂磨煤机负荷检测方法[J]. 热力发电,2010,39（9）：78-80.
WU Tong, LI Peng-fei, SI Gang-feng, et al . Detection method for coal pulverizer load in thermal power plants[J]. Thermal Power Generation, 2010, 39(9): 78-80.
[7] 王靖程,任志文,舒进,等. 基于最小均方误差准则的ICA过程监控方法[J]. 热力发电,2013,42（11）：121-126.
WANG Jing-cheng, REN Zhi-wen, SHU Jin, et al . A minimum mean square error based novel process monitoring method with independent component analysis[J]. Thermal Power Generation. 2013, 42(11): 121-126.
[8] 孙丽华,曲莹军,张彦斌,等. 钢球磨煤机负荷检测方法的研究及实现[J]. 热力发电,2004,33（11）：25-27.
SUN Li-hua, QU Ying-jun, ZHANG Yan-bin, et al . The research and implementation of ball mill load measurement[J]. Thermal Power Generation. 2004, 33(11): 25-27.
[9] 赵登峰,王国强,许纯新. 基于小波神经网络的球磨机煤位监测研究[J]. 矿山机械,2003,31（10）：14-16.
ZHAO Deng-feng, WANG Guo-qiang, XU Chun-xin. The research of ball mill load measurement based on wavelet neural network[J]. Mining & Processing Equipment, 2003, 31(10): 14-16.
[10] KANG ES, GUO YG, DU YY, et al . Acoustic vibration signal processing and analysis in ball mill[C]// The Sixth World Congress on Intelligent Control and Automation, Dalian, China, 2006: 6690-6693.
[11] 沙毅,曹英禹,郭玉刚. 磨煤机振声信号分析及基于BP网的料位识别[J]. 东北大学学报,2006,27（12）：1319-1323.
SHA Yi, CHAO Ying-Yu, GUO Yu-Gang. Analysis of acoustic signal and BP neural network-based recognition of level of coal in ball mill[J]. Journal of Northeastern University(Natural Science). 2006, 27(12): 1319-1323.
[12] SI Gangquan, CAO Hui, ZHANG Yanbin, et al . Experimental investigation of load behaviour of an industrial scale tumbling mill using noise and vibration signature techniques[J]. Minerals Engineering, 2009, 22(15): 1289-1298.
[13] 王靖程,诸文智,张彦斌. 基于面积的改进灰关联度算法[J]. 系统工程与电子技术,2010,32（4）：777-779.
WANG Jing-cheng, ZHU Wen-zhi, ZHANG Yan-bin. Improved algorithm of grey incidence degree based on area[J]. Journal of Systems Engineering and Electronics, 2010, 32(4): 777-779.
[14] XU Lijun, ZHANG Jianqiu, YAN Yong. A wavelet-based multi- sensor data fusion algorithm[J]. IEEE Transactions on Instrumentation and Measurement, 2004, 53(6): 1539-1546.

[1]	刘习文, 彭卓寅, 胡新强, 叶泽, 何会学, 蔡睿, 魏文博. 燃煤火电厂年度燃料成本最小化决策模型及应用[J]. 中国电力, 2022, 55(6): 202-207.
[2]	晏敏, 张杨, 郭博闻, 朱跃. 基于全寿命周期成本的SCR脱硝系统优化分析[J]. 中国电力, 2021, 54(3): 191-196.
[3]	杨阳, 胡大龙, 黄倩, 许臻, 王璟, 吴火强, 王博. 火电厂废水排放控制政策法规与技术路线综述[J]. 中国电力, 2020, 53(8): 131-138.
[4]	邓宇强, 齐佶, 王启亮, 祁东东, 宋飞, 李海洋, 程家庆, 王冬梅, 马彦斌. 停用保护剂对锅炉启停期间水汽中TOCi的影响研究[J]. 中国电力, 2020, 53(6): 161-165,196.
[5]	王霂晗, 朱林, 张晶杰, 杨帆. 欧盟火电厂二氧化碳排放在线监测系统质量保证体系对中国的启示[J]. 中国电力, 2020, 53(3): 154-158,176.
[6]	唐伟峰, 张佳琦, 李飞. 无磷阻垢剂WS330海水循环冷却阻垢试验研究[J]. 中国电力, 2019, 52(9): 161-166,178.
[7]	赵秀勇, 朱法华, 王圣, 孙雪丽, 徐静馨. 江苏省火电超低排放对环境空气中PM_2.5质量浓度影响模拟研究[J]. 中国电力, 2019, 52(9): 167-172.
[8]	李昊燃, 徐永峰, 马翔. 大型电站烟风管道节能优化及工程应用[J]. 中国电力, 2019, 52(7): 123-131.
[9]	段旭晨, 彭道刚, 姚峻, 赵慧荣, 夏飞. 基于SA-PSO-AHP的火电厂控制系统信息安全威胁评估[J]. 中国电力, 2019, 52(5): 29-35.
[10]	庞乐, 赵玉柱, 张帅, 李鹏. 加装低压省煤器对汽轮机排汽量的影响研究[J]. 中国电力, 2019, 52(4): 133-137.
[11]	韩超, 马欣欣, 沈维春, 董士波, 王秀娜, 曹旭, 徐剑锋. 智慧安全系统在火电厂中的应用研究[J]. 中国电力, 2019, 52(3): 127-132.
[12]	李玉宇, 吴火强, 余伟权, 毛进, 连坤宙. 珠海电厂精处理系统再生废水综合利用改造方案[J]. 中国电力, 2019, 52(3): 140-145.
[13]	肖育军, 邹毅辉, 李彩亭, 周雪斌. SCR系统结构模型与数值模型的适用性分析[J]. 中国电力, 2019, 52(3): 146-152,160.
[14]	张楚, 杨毅, 金格, 刘石, 高庆水. 循环水泵动态镜板翘曲故障诊断及振动评价讨论[J]. 中国电力, 2019, 52(2): 144-148,177.
[15]	王亚欧, 陶谦, 肖杰, 陈波. 1 000 MW双切圆燃烧锅炉干湿态转换过程中水冷壁温度控制[J]. 中国电力, 2019, 52(1): 161-165,173.