中国电力 ›› 2014, Vol. 47 ›› Issue (6): 86-89.DOI: 10.11930/j.issn.1004-9649.2014.6.86.3

• 发电 • 上一篇    下一篇

600 MW亚临界机组转子热弯曲的振动特征分析

安宏文1, 2, 胡三高1, 马志勇1, 滕伟1, 柳亦兵1   

  1. 1. 华北电力大学 能源动力与机械工程学院,北京 102206;
    2. 内蒙古京隆发电有限责任公司,内蒙古 丰镇 012100
  • 修回日期:2014-01-09 出版日期:2014-06-18 发布日期:2015-12-08
  • 作者简介:安宏文(1969—),男,辽宁凤城人,教授级高工,从事能源及发电领域的管理和研究。E-mail: anhongwen@jinglongpower.com

Analysis on Hot Bending Vibration Characteristics of 600-MW Subcritical Steam Turbine Unit Rotors

AN Hong-wen1, 2, HU San-gao1, MA Zhi-yong1, TENG Wei1, LIU Yi-bing1   

  1. 1. School of Energy Power and Mechanical Engineering, North China Electric Power University, Beijing 102206, China;
    2. Jinglong Power Plant of Beijing Energy Investment Holding Co. Ltd., Fengzhen 012100, China
  • Revised:2014-01-09 Online:2014-06-18 Published:2015-12-08

摘要: 针对某台600 MW亚临界汽轮发电机组高中压转子的振动缓慢爬升的异常现象,通过分析该机组带负荷运行和启停机过程的振动特征,确定高中压转子存在偏向一侧的均匀热变形,形成和原始不平衡质量同方向的偏心。产生转子热变形的原因可能是转子存在材质不均匀,而非造成临时热变形的局部受热不均。在这种转子状态下,停机过程必须采取一些现场特殊措施,否则可能由于振动过大,造成停机过程中出现机组设备的损坏。

关键词: 600 MW亚临界汽轮机组, 转子热弯曲, 振动分析

Abstract: In this paper, the study is carried out on the abnormal HP-IP rotor vibration with slowly increasing amplitude in one 600-MW subcritical steam-turbo generator. Through the analysis on the vibration characteristics during normal loading operation, startup process and shutdown process, it is concluded that evenly hot deformation occurs on one side of the rotor, which causes eccentricity in the same direction of the original unbalancing mass. The hot deformation may come from the uneven material property rather than the temporary hot deformation caused by uneven local heating. Under this rotor condition, special measures must be taken during shutdown process to prevent turbine damage from severe vibration.

Key words: 600-MW subcritical steam turbine unit, hot bending of rotor, vibration analysis

中图分类号: