基于奇异点检测的单端行波测距方法改进

doi:10.11930/j.issn.1004-9649.2013.9.71.3

中国电力 ›› 2013, Vol. 46 ›› Issue (9): 71-74.DOI: 10.11930/j.issn.1004-9649.2013.9.71.3

基于奇异点检测的单端行波测距方法改进

辛超山, 李凤婷

新疆大学电气工程学院,新疆乌鲁木齐 830047

收稿日期:2013-05-12 出版日期:2013-09-23 发布日期:2015-12-10
作者简介:辛超山（1989—）,男,新疆昌吉人,硕士研究生,从事电力系统继电保护研究。
基金资助:
国家自然科学基金资助项目（51267019）; 新疆维吾尔自治区自然科学基金资助项目（2012211A002）

Improvement on Single-Ended Traveling Wave Based Fault Location Through Singular Point Detection

XIN Chao-shan, LI Feng-ting

Electrical Engineering College, Xinjiang University, Urumqi 830047, China

Received:2013-05-12 Online:2013-09-23 Published:2015-12-10

摘要/Abstract

摘要： 单端测距不受通信条件的限制成为研究的热点问题,通过小波变换可精确定位第1个波头。但在复杂线路中,由于波形叠加、交叉透射波等因素的影响,第2个反射波会迅速衰减,降低了测量精度。在分析不同阻抗线路行波折反射规律、行波提取及小波变换基础上,针对第2个波头的衰减,提出对变换后的第2个反射波进行平均化处理,提高测量精度;建立了改进的基于单端电气量行波测距的流程,并通过Matlab仿真分析了此方法的效果,结果表明,与模极大值法相比,改进的均值处理方法能提高测距精度。

关键词: 故障测距, 反向行波, 突变性检测, 均值化

Abstract: The single-ended traveling wave based fault location became the focus of study due to the feature that it is not subject to communication constraints. Through wavelet transforming, the first wave head can be located precisely. But, in complex circuits, the second reflected wave will decay rapidly due to superimposed waveforms and cross transmission waves, which leads to the decrease of measuring accuracy. In this paper, based on the analysis of refraction-reflection law for different impedance line, the extraction of traveling waves and wavelet transformation, the method of averaging processing for the transformed second wave to improve the measuring accuracy is proposed. An improved scheme of traveling wave based fault location using single end electric parameters is established and simulation is performed in Matlab. The results show that, compared with the modulus maxima method, the updated averaging processing can significantly improve the fault location accuracy. The correctness and effectiveness of the new scheme are proved.

Key words: fault location, reverse traveling wave, mutation detection, averaging

中图分类号:

TM773

辛超山, 李凤婷. 基于奇异点检测的单端行波测距方法改进[J]. 中国电力, 2013, 46(9): 71-74.

XIN Chao-shan, LI Feng-ting. Improvement on Single-Ended Traveling Wave Based Fault Location Through Singular Point Detection[J]. Electric Power, 2013, 46(9): 71-74.

导出引用管理器 EndNote|Ris|BibTeX

链接本文: https://www.electricpower.com.cn/CN/10.11930/j.issn.1004-9649.2013.9.71.3

https://www.electricpower.com.cn/CN/Y2013/V46/I9/71

参考文献

1 葛耀中. 新型继电保护和故障测距的原理与技术[M]. 2版. 西安：西安交通大学出版社,2007.
[2] 李幼仪,董新洲,孙元章. 基于电流行波的输电线横差保护[J]. 中国电机工程学报,2002,22（11）：7-11.
LI You-yi, DONG Xin-zhou, SUN Yuan-zhang. Current-travelling- wave-basde protection of double-circuit transmission line[J].Proceedings of the CSEE, 2002, 22(11): 7-11.
[3] 任达勇,王志滨,冯鸫,等. 基于行波原理的直流输电线路过渡电阻在线测量[J]. 中国电力,2010,43（3）：23-26.
REN Da-yong, WANG Zhi-bin, FENG Dong, et al . On-line measuring of fault resistance on HVDC transmission lines based on traveling wave principle [J]. Electric Power, 2010, 43(3): 23-26.
[4] 康小宁,索南加乐. 基于参数识别的单端电气量频域法故障测距原理[J]. 中国电机工程学报,2005,25（2）：25-30.
KANG Xiao-ning, SONGNAN Jia-le. Frequency domain method of fault location based on parameter identification-using one terminal data [J]. Proceedings of the CSEE, 2005, 25(2): 25-30.
[5] 陈晓娟,王丽,隋吉生,等. 一种配电网单相接地故障定位新方法[J]. 中国电力,2011,44（10）：33-36.
CHEN Xiao-juan, WANG Li, SUI Ji-sheng, et al . A new method of single-phase ground fault location in 10 kV distribution network[J]. Electric Power, 2011, 44(10): 33-36.
[6] 黄悦华,王永辉. 暂态初始行波相位比较法接地故障选线研究[J]. 中国电力,2008,41（4）：11-14.
HUANG Yue-hua, WANG Yong-hui. A study of earth fault detection by comparing phase of initial transient traveling wave [J]. Electric Power, 2008, 41(4): 11-14.
[7] 李一峰,陈平. 一种反应输电线路故障行波的测距方法[J]. 中国电力,2007,40（12）：68-71.
LI Yi-feng, CHEN Ping. A novel method of fault location for transmission lines using traveling waves [J]. Electric Power, 2007, 40(12): 68-71.
[8] 秦小安,曾祥君,万磊,等. 基于网络的电网故障行波保护方法[J]. 中国电力,2009,42（8）：15-18.
QIN Xiao-an, ZENG Xiang-jun, WAN Lei, et al . Traveling wave protection method of power grid fault based on network [J].Electric Power, 2009, 42(8): 15-18.
[9] 陈铮,董新洲,罗承沐. 单端工频电气量故障测距算法的鲁棒性[J]. 清华大学学报：自然科学版, 2003,43（3）：310-313.
CHEN Zheng, DONG Xin-zhou, LUO Cheng-mu. Robustness of one-term inal fault location algorithms based on power frequency quality [J]. Tsinghua University: Sci & Tech, 2003, 43(3): 310-313.
[10] 吴萍,张尧. 基于单端电气量的故障测距算法[J]. 电力系统及其自动化学报,2003,15（4）：5-7,31.
WU Ping, ZHANG Yao. Location using one-term inal data for transmission line [J]. Proceedings of the EPSA, 2003, 15(4): 5-7, 31.
[11] 徐青山,陈锦根,唐国庆. 考虑母线分布电容影响的单端行波测距法[J]. 电力系统自动化,2007,31（2）：70-73.
XU Qing-shan, CHEN Jin-gen, TANG Guo-qing. Single ended fault location approach considering bus distributed capacitance effect[J]. Automation of Electric Power Systems, 2007, 31(2): 70-73.
[12] 钟小垒,李京. 基于行波耦合原理的高压直流输电系统接地极引线故障测距[J]. 山东理工大学学报,2012,26（3）：54-59.
ZHONG Xiao-lei, LI Jing. Fault location of grounded electrode lead in HVDC system based on the principle of coupled travelling wave [J]. Journal of Shandong University of Technology,2012, 26(3): 54-59.
[13] 张德丰. Matlab小波分析[M]. 北京：机械工业出版社,2009.
[14] 清华大学. HPR-7000高精度故障录波与测距装置使用说明[S]. 北京：清华大学,2010.
[15] 王志华.超高压输电线路故障行波定位及高压变频技术研究[D]. 武汉：华中科技大学,2004.

[1]	丁建忠，鲍有理，李澄. 基于电流计算的同杆双回线故障测距算法研究[J]. 中国电力, 2016, 49(8): 59-63.
[2]	杨立红, 杨明玉. 基于固有频率的高压直流输电线路故障测距[J]. 中国电力, 2013, 46(7): 82-86.

基于奇异点检测的单端行波测距方法改进

Improvement on Single-Ended Traveling Wave Based Fault Location Through Singular Point Detection

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 2

编辑推荐

Metrics

模态框（Modal）标题

基于奇异点检测的单端行波测距方法改进

Improvement on Single-Ended Traveling Wave Based Fault Location Through Singular Point Detection

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 2

编辑推荐

Metrics